Epson RC700 Manual page 139

Editing of input / output size
You can change the input/output size of the EtherNet/IP slave board if necessary.
1.
2.
3.
4.
5.
RC700 / RC90 Option Fieldbus I/O Rev.12
Select [Setup]-[System Configuration] and display the [System Configuration] dialog
box.
Select [Inputs / Outputs]-[Fieldbus Slave]-[General].
Change the settings of [Input Bytes] and [Output Bytes].
In this example, both of them are changed to 20 Bytes.
Click <Apply>.
Click <Close> and the following dialog box appears.
The Robot Controller automatically starts rebooting.
2. Installation
129