Mirroring The Sewing Program; Displaying The Software Version - DURKOPP ADLER 650-10 Operating Instructions Manual

Service settings via software (OP3000)
Operating Instructions 650-10 - 03.0 - 08/2016
5.6.5

Mirroring the sewing program

The sleeve side already programmed is mirrored over to the other
sleeve side.
Proceed as follows to mirror a sewing program:
1. Press the
 The softkey menu appears on the display:
Fig. 39: Mirroring the sewing program
2. Press the
3. Press the ESC key.
 The controller switches to Edit mode to Automatic mode.
5.7

Displaying the software version

To display the software version:
1. Switch off and on the machine.
 The splash screen appears on the display:
• On the left, the control panel firmware
• On the right, the controller software version
Fig. 40: Displaying the software version
 The machine performs a reference run:
The display shows the sewing program last used,
or Manual mode.
key.
key.
61