Length Correction (Length Correction) - DURKOPP ADLER 650-10 Operating Instructions Manual

102
6.5.5

Length correction (LENGTH CORRECTION)

All the sewing steps are graded with the same factor.
In some sewing steps it is important for the quality of the result
that the grading is greater or less than this.
You can use the length correction to achieve these local
adjustments.
Prerequisite:
• Operating mode EDIT is displayed.
Use the length correction as follows:
1. Tap the P button.
LEN
 The LENGTH CORRECTION user interface is displayed.
Fig. 66: Length correction (LENGTH CORRECTION) (1)
2. Sew the sewing step.
3. Switch to the next sewing step by tapping on the number of
the first sewing step or by using the knee lever.
 The sewing progress is displayed graphically.
Settings via software (OP7000)
Operating Instructions 650-10 - 03.0 - 08/2016