DURKOPP ADLER 650-10 Operating Instructions Manual page 148

Hide thumbs Also See for 650-10:
Table of Contents

Advertisement

Code
Type
2280
Error
2281
Error
2282
Error
2283
Error
2284
Error
2285
Error
2286
Error
2287
Error
2288
Error
146
Possible causes
Direction of rotation
Error in the reference run
Stepper motor current error
Stepper motor overcurrent
Software error
Stepper motor insulation
error
Software error
Software error
Software error
Operating Instructions 650-10 - 03.0 - 08/2016
Troubleshooting
Remedial action
• Replace the encoder
• Check plug assignment and
change, if necessary
• Check wiring in machine
distributor and change it,
if necessary
• Test stepper motor phases
and check for correct value
• Replace the reference
switch
• Remove the blockage
• Check the encoder cable
and replace, if necessary
• Replace the stepper motor
• Replace the sewing motor
cable
• Replace the stepper motor
• Replace the control
• Perform reset
• Perform a software update
• Contact customer service
• Check motor phase and
PE for low-impedance
connection
• Replace the encoder
• Replace the stepper motor
• Perform reset
• Perform a software update
• Contact customer service
• Perform reset
• Perform a software update
• Contact customer service
• Perform reset
• Perform a software update
• Contact customer service

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents