DURKOPP ADLER 650-10 Operating Instructions Manual page 145

Troubleshooting
Code Type
2180 Error
2181 Error
2182 Error
2183 Error
2184 Error
2185 Error
2186 Error
2187 Error
2188 Error
Operating Instructions 650-10 - 03.0 - 08/2016
Possible causes
Direction of rotation
Error in the reference run
Stepper motor current error
Stepper motor overcurrent
Software error
Stepper motor insulation
error
Software error
Software error
Software error
Remedial action
• Replace the encoder
• Check plug assignment and
change, if necessary
• Check wiring in machine
distributor and change it,
if necessary
• Test stepper motor phases
and check for correct value
• Replace the reference
switch
• Remove the blockage
• Check the encoder cable
and replace, if necessary
• Replace the stepper motor
• Replace the sewing motor
cable
• Replace the stepper motor
• Replace the control
• Perform reset
• Perform a software update
• Contact customer service
• Check motor phase and
PE for low-impedance
connection
• Replace the encoder
• Replace the stepper motor
• Perform reset
• Perform a software update
• Contact customer service
• Perform reset
• Perform a software update
• Contact customer service
• Perform reset
• Perform a software update
• Contact customer service
143