DURKOPP ADLER 650-10 Operating Instructions Manual page 80

78
Symbol/button
To set a parameter:
1. Tap the desired button.
 The user interface for setting the desired parameter is
displayed.
For some parameters the setting is more than just a numerical
value. These more complex parameters are described in detail
below.
Settings via software (OP7000)
Meaning
Applying a % correction to the fullness
values of all sewing steps,  p. 82
Setting the needle thread tension.
If changed in AUTO operating mode, the
value is permanently saved in the sewing
program.
Setting the stitch length in mm.
If changed in AUTO operating mode, the
value is permanently saved in the sewing
program.
Operating Instructions 650-10 - 03.0 - 08/2016