DURKOPP ADLER 650-10 Operating Instructions Manual page 142

Code Type
1055 Error
1056 Error
1058 Error
1060 Error
1061 Error
1062 Error
1120 Error
1203 Information
1302 Error
1330 Error
140
Possible causes
Sewing motor overload (I²T):
• Sewing motor not moving
freely or blocked
• Sewing motor defective
• Controller defective
Sewing motor
overtemperature:
• Sewing motor not moving
freely
• Sewing motor defective
• Controller defective
Sewing motor speed greater
than setpoint:
• Reference switch defective
• Sewing motor defective
PowerParts
Sewing motor disturbance:
• Encoder defective
• Sewing motor defective
Sewing motor disturbance
(IDMA auto increment)
Software error:
• Parameter not initialized
Sewing motor:
Position not reached
Sewing motor current error:
• Sewing motor blocked
• Encoder cable not
connected or defective
• Encoder defective
Sewing motor not responding • Switch the machine off and
Operating Instructions 650-10 - 03.0 - 08/2016
Troubleshooting
Remedial action
• Remove the cause of the
stiff movement or blockage
• Replace the sewing motor
• Replace the control
• Correct the cause of not
moving freely
• Replace the sewing motor
• Replace the control
• Replace the reference
switch
• Replace the sewing motor
• Replace the control
• Switch the machine off and
on again
• Replace the encoder
• Replace the sewing motor
• Contact customer service
• Switch the machine off and
on again
• Perform a software update
• Switch the machine off and
on again
• Perform a software update
• Contact customer service
• Remove the blockage
• Check the encoder cable
and replace, if necessary
• Replace the sewing motor
on again
• Perform a software update
• Contact customer service