Parameters That Can Be Set - DURKOPP ADLER 650-10 Operating Instructions Manual

72
6.3.1

Parameters that can be set

The following table lists the parameters that can be set in MAN
operating mode.
Symbol/button
To set a parameter:
1. Tap the desired button.
 The user interface for setting the desired parameter is
displayed.
For some parameters the setting is more than just a numerical
value. These parameters are described below.
Settings via software (OP7000)
Meaning
Setting the fullness,  p. 73
Set the curve support.
Other program parameters in manual
mode MAN,  p. 74
Inputting the needle thread tension
Inputting the stitch length in mm
Operating Instructions 650-10 - 03.0 - 08/2016