DURKOPP ADLER 650-10 Operating Instructions Manual page 57

Service settings via software (OP3000)
Operating Instructions 650-10 - 03.0 - 08/2016
Use   to select the sewing program to be edited, the sleeve
2.
/
side and the step; and use 
Information
The step to be edited can also be selected using the knee lever.
 The selected step is shown bold in the program bar.
Use   to select the parameter to the changed for the res-
3.
/
pective step, and use 
Changing further parameters for the current step
Use  to select the field
1.
/
2. Press the OK key.
 The submenu opens.
Use   to select the desired parameter.
3.
/
4. Press the OK key to activate or deactivate the parameter, or
use   to change its value and press OK to confirm it.
/
Symbol Meaning
Step. Len. (step length)
Auto Forward (automatic step progression)
Alternate (sewing foot stroke height)
Foot Press (sewing foot pressure)
Exit the submenu using ESC or .
5.
You can exit Edit mode with a press of the ESC key.
 to edit them.
/
 to change it.
/
.
55