Table of Contents
Advertisement
128
8.9.2
Connecting the setpoint device to the controller
Fig. 86: Connecting the setpoint device to the controller
①
(1) - Setpoint device for main pedal
Connect the setpoint device to the controller as follows:
1.
Connect the setpoint device for the main pedal to
connector X5b
2.
If present, connect the setpoint device of the additional pedal
to connector X440; the cable hangs freely in the cable har-
ness.
8.9.3
Establishing equipotential bonding
Important
Before putting the machine into operation, you must establish
equipotential bonding in all necessary places.
Establish equipotential bonding as follows:
1.
Establish equipotential bonding as specified in the wiring
diagram ( p. 161).
.
Operating Instructions 650-10 - 03.0 - 08/2016
Setup
Hide quick links:
Advertisement
Table of Contents
