DURKOPP ADLER 650-10 Operating Instructions Manual page 98

96
Symbol/button
To set a parameter:
1. Tap the desired button.
 The user interface for setting the desired parameter is
displayed.
For some parameters the setting is more than just a numerical
value. These more complex parameters are described in detail
below.
Settings via software (OP7000)
Meaning
Other program parameters under
PROGRAMMING,  p. 99
Set the fullness in the current sewing step,
 p. 98
Set the curve support in the current sewing
step
Set the needle thread tension in the current
sewing step
Set the stitch length in mm in the current
sewing step
Switch the seam length measurement in
the current sewing step on or off
Other sewing step parameters under
PROGRAMMING,  p. 100
Operating Instructions 650-10 - 03.0 - 08/2016