DURKOPP ADLER 650-10 Operating Instructions Manual page 141

Troubleshooting
Code Type
1006 Error
1007 Error
1008 Error
1010 Error
1011 Error
1012 Error
1051 Error
1052 Error
1053 Error
1054 Error
Operating Instructions 650-10 - 03.0 - 08/2016
Possible causes
Sewing motor error:
• Max. speed exceeded
• Sewing motor cable
defective
• Sewing motor defective
Error in the reference run
Sewing motor encoder error
Sewing motor synchroniza-
tion error:
• External synchronizer
plug (Sub-D, 9-pin) not
connected
Sewing motor synchroniza-
tion error (Z pulse)
Sewing motor synchroniza-
tion error
Sewing motor timeout:
• Cable to sewing motor
Reference switch defective
• Reference switch defective
Sewing motor overcurrent:
• Sewing motor cable
defective
• Sewing motor defective
• Controller defective
Sewing motor overvoltage
Internal short circuit
Remedial action
• Switch the machine off and
on again
• Replace the encoder
• Perform reset
• Replace the sewing motor
• Contact customer service
• Replace the encoder
• Eliminate stiff movement in
the machine
• Replace the encoder
• Connect plug of external
synchronizer to controller,
use correct connection
(Sync)
• Replace the reference
switch or synchronizer
• Only required for machines
with transmission!
• Switch off the controller,
use handwheel to turn and
switch on the controller
again
• If error is not corrected,
check encoder
• Replace the synchronizer
• Replace the cable
• Replace the reference
switch
• Replace the sewing motor
cable
• Replace the sewing motor
• Replace the control
• Check the mains voltage
• Replace the control
139