DURKOPP ADLER 650-10 Operating Instructions Manual page 96

94
7. Tap the END button or cut the threads.
 There are 3 variants for the sewing program response -
depending on the user's input method:
Variant
The last programmed sewing step was sewn
but not cut off, then ended with END.
The last programmed sewing step was sewn
and threads cut off.
All sewing steps were input manually and
ended with END.
8. If the threads were not cut after sewing, the message Cut
off thread appears.
 The message is cleared, and the following selection window
appears:
Fig. 61: Creating a new seam program (PROGRAMMING) (3)
9. Select whether the new sewing program should be mirrored
for the other side of the sewing material (Mirror program-
med side to other side), the other side of the sewing
Settings via software (OP7000)
Operating Instructions 650-10 - 03.0 - 08/2016
Program display
continue with step 8
continue with step 9
continue with step 9