Setting The Needle Thread Regulator - DURKOPP ADLER 650-10 Operating Instructions Manual

Operation
Operating Instructions 650-10 - 03.0 - 08/2016
4.7.3

Setting the needle thread regulator

The needle thread regulator regulates the amount of needle thread
required for forming the stitch. An optimum sewing result is pos-
sible only when the needle thread regulator is exactly adjusted.
Proper setting
With the proper setting the needle thread loop must slide over the
thickest part of the hook at low tension.
When the largest thread quantity is required then the thread
tension spring (3) must be pulled approx. 0.5 mm down from its
upper end position. This occurs when the needle thread loop
matches the maximum hook diameter.
Fig. 12: Setting the needle thread regulator
①
②
③
(1) - Screw
(2) - Needle thread regulator
To set the needle thread regulator:
1. Loosen the screw (1).
2. Change the setting of the needle thread regulator (2).
3. Tighten the screw (1).
(3) - Thread tensioning spring
31