Edit Mode; Edit The Sewing Program - DURKOPP ADLER 650-10 Operating Instructions Manual

54
Fig. 27: Creating a program by sewing the seam (1)
6. Sew the overlap.
7. Press the Pedal fully back.
 The sleeve that was created is mirrored, depending on the
settings at the technician level.
The controller switches to Automatic mode.
The sewing program that was just created is activated.
Fig. 28: Creating a program by sewing the seam (2)
5.6

Edit mode

Prerequisite: You are in Automatic mode ( p. 45).
5.6.1

Edit the sewing program

1. In Automatic mode, press the P key.
 The controller switches to Edit mode.
The sewing program previously selected can now be edited.
The display shows the following information,
the P in the program number field flashes:
Fig. 29: Edit the sewing program
Service settings via software (OP3000)
Operating Instructions 650-10 - 03.0 - 08/2016