Table of Contents
Advertisement
Settings via software (OP7000)
Operating Instructions 650-10 - 03.0 - 08/2016
Fig. 67: Length correction (LENGTH CORRECTION) (2)
4.
Do the same with all further sewing steps.
5.
After the last sewing step tap the END button.
This closes the length correction, and the operating
mode EDIT ( p. 85) opens.
6.6
Displaying the software version
To display the software version:
1.
Switch on and off the machine.
The following appears on the display:
• On the left, the class
• On the right, the firmware
The machine performs a reference run.
The controller starts in the operating mode that was active
when it was switched off - MAN or AUTO.
6.7
Operating mode SERVICE
More information on the contents of Service mode can be found
in the Service Instructions.
103
Hide quick links:
Advertisement
Table of Contents
