Cancel Sewing Program - DURKOPP ADLER 650-10 Operating Instructions Manual

Service settings via software (OP3000)
Operating Instructions 650-10 - 03.0 - 08/2016
The following table lists the functions that can be performed in the
course of the seam.
Key/Pedal Function
Plus/minus Temporary correction of the fullness value
and (valid only for the current step)
0 – 16
Additional Temporary correction of the fullness value or
pedal the curve support (depending on the setting in the
(optional) technician level)
(valid only for the current step)
Knee lever Next program step
 
Stop forward/back or to the start of the step
/
3
Switch the sleeve side (if programmed) in the 1
at the start of the step
 
Correction of the thread tension
/
The value is saved
P, F, S, OK No function assigned
Press the Lift sewing foot
Pedal halfway
back
Press the Cut thread
Pedal fully The program remains stopped at the cutoff point
back (does NOT apply to the last step)
Lower softkey Softkey menu
( p. 41)
5.4.2

Cancel sewing program

1. Press the Pedal fully back.
 The thread is cut.
2. Press the ESC key.
 The sewing program is canceled.
st
step
49