MAN mode Other program parameters
74
Setting the curve support
The following table lists the symbols and buttons for manually
setting the curve support.
The default setting is a value of 2.
Symbol/button
To set the curve support:
1.
Input the curve support using the buttons 0 to 6.
A tap on the Other program parameters button will bring up an
overview of all available parameters.
Fig. 46: Other program parameters
Settings via software (OP7000)
Meaning
Inputting the curve support.
The curve support is displayed by a button
highlighted in red.
Operating Instructions 650-10 - 03.0 - 08/2016