Sewing Process - DURKOPP ADLER 650-10 Operating Instructions Manual

Settings via software (OP7000)
Operating Instructions 650-10 - 03.0 - 08/2016
Parameters
Manual Backtack
Needle Stop Position Up
Foot Stroke Alternation
Foot Pressure
Backtack at Start
Backtack at End
Thread Trimmer
6.3.2

Sewing process

This is how you sew without fullness:
1. Set all fullness values to 0 ( p. 72).
2. Input the values for needle thread tension and stitch length.
3. Press the pedal forwards and sew.
 The length in mm sewn in the seam is displayed.
When the thread is cut, the display is reset.
This is how you sew with fullness:
1. Change the desired fullness ( p. 72).
2. Push the pedal forwards and sew.
Meaning
Manual bartack
Needle position up when sewing stops
Value range: 1 (= on) or 0 (= off)
Sewing foot alternation whilst the needle is
in the sewing material
Value range: 0 – 2.5 mm
Sewing foot pressure
Value range: 1 – 10
Bartack at seam beginning
Value range: 1 (= on) or 0 (= off)
Bartack at seam end
Value range: 1 (= on) or 0 (= off)
Thread trimmer
Value range: 1 (= on) or 0 (= off)
75