Installation Locations For The Calibration Tools - ABB IRB 2600 Series Product Manual

Hide thumbs Also See for IRB 2600 Series:

Table of Contents

5 Calibration

5.4.3 Installation locations for the calibration tools

Location of fixed calibration items

This section shows how the robot is equipped with items for installation of

calibration tools for Axis Calibration (fixed calibration pins and/or bushings).

Installed calibration tools are not shown.

A fixed calibration pin and a bushing for the movable calibration tool are located

on each axis as follows.

If there is not enough space on an axis to install a fixed calibration pin, the axis is

equipped with two bushings instead, for installation of two calibration tools when

calibration is carried out. This is shown in the figure.

IRB 2600-20/1.65, IRB 2600-12/1.65, IRB 2600-12/1.85, IRB 2600ID-15/1.85, IRB 2600ID-8/2.0

xx1800000963

IRB 2600 Type C-20/1.65, IRB 2600 Type C-12/1.65

xx1800000964

Continues on next page

Product manual - IRB 2600

3HAC035504-001 Revision: Q