External Component Replacement
USB Port Cover Replacement
8.4
Requirements:
WT-CWU USB Port Cover Kit
•
Torque driver with #2 Phillips bit
•
WARNING:
Disconnect the warming unit's power cord from the AC power source before
performing this procedure.
To replace the USB port cover:
Remove the screw securing the cover over the USB port. Remove the cover.
1.
Place the new cover in position and install the screw. Tighten the screw to 1.1 to
2.
1.5 N-m (9.7 to 13.3 lb-in).
8-4
Figure 8-3. USB Port Cover
(page
A-2)
Service Manual