Administering Dial-Pattern Parameters - Avaya G450 Manual

Note:
The North American Public Network Service Providers do not allow any part of a
Note:
T1 to be shared outside of this NFAS-trunk group. In other words, they do not
allow one of the T1 interfaces (of this NFAS group) to be fractionalized into two or
more uses. It must be dedicated to this given customer. Therefore, the following
usage rules apply:
- All members of an NFAS DS1 (that are administered) must belong to the same
trunk-group
- All members of this trunk-group must belong to a single signaling group
5. Enter show to check the signaling groups administration.
The report lists the signaling groups parameters. For example:
Sig-group Tg-Select Assoc-Sig Prime-Dchan Nfas-Modules/Nfas-Id
--------- --------- --------- ----------- -------------------------------------
10
6. Enter exit to leave the sig-group context in SLS.

Administering dial-pattern parameters

1. Enter dial-pattern dialed-string, where dialed-string is a dial pattern to be
used on outgoing calls.
The command line prompt changes to super-sls/dial-pattern
<dialed-string>. If you want to remove the incoming routing treatment from the SLS
administration, enter exit to leave the second-level dial-pattern context and return to
the (super-sls)# context, and then enter clear dial-pattern dialed-string.
2. Enter set type dial-type, where dial-type specifies the type of outbound call and
the dialing privileges available for outbound calls. The following call types are available:
emer. Emergency calls only
●
fnpa. 10-digit North American Numbering Plan calls
●
hnpa. 7-digit North American Numbering Plan calls
●
intl. Public-network international number calls
●
iop. International operator calls
●
locl. Public-network local number calls
●
natl. Non-North American Numbering Plan calls
●
op. Operator calls
●
svc. Service calls
●
98 yes 005v424
Configuring SLS
Issue 1 January 2008
-
181