Network Connection; Connection By Factory Default Settings - ICP DAS USA UA-5200 Series User Manual

2.2. Network Connection

This section introduces how to connect to the UA-5200 Web User Interface (UA Web UI).
The new user or setting the new UA controller is recommended to follow the method in the
first session. (The same method as the "UA-5200 Quick Start" manual)
2.2.1.

Connection by Factory Default Settings

The factory default settings of the UA-5200 are as the following table:
Network
OS
Account
Web UI
Account
1. Change the PC's IP setting as following. (Write down the PC original network settings
before modify.)
2. Make sure the PC and UA-5200 is connecting through Ethernet. And then open a PC
side browser (Ex: Chrome, IE...). Type http://192.168.255.1 in the URL address. Use
default Web UI username/password root/root to login the system.
Factory Default Settings of UA-5200
IP 192.168.255.1
Netmask 255.255.0.0
Gateway 192.168.1.1
Username root
Password icpdas
Username root
Password root
IP
Subnet mask
Gateway address
UA-5200 Series User Manual V4.3
Assign UA-5200 a new IP
setting according to your
case.
After login, change your
password ASAP. (Refer
Manual)
192.168.255.10
255.255.0.0
192.168.1.1
18
ICP DAS
User