2. Quick Start: Hardware/Network Connection
This chapter describes the devices hardware connection, network connection and quick setting for the
BRK Controller, and how to connect to the BRK controller web-based UI via a browser. Next chapter will
set up web functions, and complete a demo project. (Please refer to Chapter 3).
2.1 Hardware Connection
This section describes the hardware wiring and connection for the BRK Series.
2.1.1 Preparations for Devices
In addition to the BRK controller (Ex: BRK-2841M) , please prepare the following:
1.
Computer: PC/NB Connect to the local network and can set up the network
2.
Ethernet Hub or Switch: e.g. NS-205
3.
Power Supply: +12 ~ +48, e.g. MDR-60-24
2.1.2 Hardware Wiring
Use LAN2 of BRK-2800 to connect to the PC through a network hub/switch, or directly connect to the
PC's network interface.
After power is connected, please [ wait for 1 minute ] for BRK boot procedure. When the "RUN" and
"PWR" lights of the BRK start to flash green and red, it means the boot is completed, and the connection
and setting can be performed.
Cable
PC/NB
Switch/Hub
Cable
Power Supply
9
BRK Series User Manual V1.0 - ICP DAS
LAN2
BRK
Series
Power Supply
12 ~ 48 VDC
S
-V
V