ICP DAS USA UA-5200 Series User Manual page 42

UA-5200 Series User Manual V4.3 ICP DAS
Step 2. Module Setting
Click the next step, and enter the Step 2 [Module Setting] of the UI setting.
This page is for setting the communication values with the connected modules. First
choose the serial port that connected with the module, and each module can give a
name (Default name: Name). Click [ ] button could add a new module, and then click
[Edit] button to configure the module content and the Modbus mapping table.
1
2.
Select the serial port
3.
Give a name,
Default: Name
4.
Click to add
Add a module (No.: 1, Name: Example1) as below, and then click [Edit] button to enter
the "Module Content Setting" page.
5
If set up a wrong module, user can click the box in the left side of the module number
and click the [Remove] button to delete the module.
42