ICP DAS USA UA-5200 Series User Manual page 27

UA-5200 Series User Manual V4.3 ICP DAS
Step 2. Module Setting
Click the next step, and enter the Step 2 [Module Setting] of the UI setting.
This step is for setting the connected modules. The user can set each module a name
(Default name: Name), click [ ] button to create a new module, and click [Edit] button
to configure the module content setting and Modbus mapping table.
<This Example>
First select the Serial Port: ttyO5, give the Module Name: M-7055D, and then click
the button [ ] to add a Module List.
1
2.
This sample: ttyO5
3.
Give a name,
Ex: M-7055D
4.
Click to add
Add a module M-7055D as below, and then click [Edit] button to enter the "Module
Content Setting" page.
5
27