Updating Middleware Via Usb (Rotary Switch: 9) - ICP DAS USA UA-5200 Series User Manual

12.2. Updating Middleware via USB (Rotary Switch: 9)

Turn the Rotary Switch of UA-5200 series to "9" can update the Middleware version via
USB.
Note: After the system version is updated, only the last network environment settings (IP,
Netmask and Gateway) of the UA series controller will be retained and the rest will
be factory recovered.
The steps:
Power off the UA-5200 hardware, and turn the Rotary Switch to "9".
1.
2. Download the Middleware package file of the UA-5200 hardware corresponding model.
The download website:
3. Save the Middleware package file into an empty FAT32 format USB drive and put to
the UA-5200 USB port.
4. Reboot the UA-5200 and wait a long buzzer sound that means of doing the version
updating.
5. Wait about five minutes until two long buzzer sounds, and then turn the Rotary Switch
to "0".
Note:
* If the buzzer makes 2 short beeps, it means the USB is not connected properly.
Please check and connect the USB again.
6. Reboot the UA-5200 again, and the system will update to the version of the package
file.
Note:
If the updating Middleware via USB still fails, please refer to
the MicroSD card to manually update the Middleware version.
http.icpdas.com.tw/pub/cd/UA-5000/middleware
211
UA-5200 Series User Manual V4.3
Appendix D
ICP DAS
for using