ICP DAS USA UA-5200 Series User Manual page 201

The settings for sending the message to the APP with the "IFTTT Condition Trigger (Line,
Facebook, Twitter)" function includes two parts:
3. UA Web Interface Setting:
In the UA Web HMI, set up the UA controller, modules, IFTTT trigger conditions, the
condition variable table, and the IFTTT event connection.
4. IFTTT Cloud Platform Setting:
In the IFTTT website, set up the "if" side service and event (this: use webhooks for the
UA), the "then" side service and action (that: user can select the service, such as the
Line, Facebook, twitter, etc.). And then fill the "Event Name" and "Key" getting from the
IFTTT website setting into the "Content Setting" of the UA We HMI. (Detail in the
Appendix C.)
This section introduces the setting part on the UA Web Interface, including the IFTTT
trigger condition, variable table and the event message. About the setting on the IFTTT
Cloud Platform, user can set up on the IFTTT website and get the "Event Name" and "Key"
for the configuration here. If you are not familiar about the IFTTT, please refer to the
Appendix C.
For the whole steps to send the message to an APP from setting the UA controller, module,
I/O variables to the IFTTT Condition Trigger, the users can refer to the
step box below.
[Step Box : IFTTT Condition Trigger (Line, Facebook, Twitter)]:
This section will introduce the setting of the IFTTT condition trigger list, variable table and
the event message.
UA-5200 Series User Manual V4.3
201
ICP DAS
Section 4.4 and the