Condition Trigger Descriptions:
The condition trigger method will different depending on the attribute of the selected
variable and the trigger will be different. There are two operation styles:
variable, then Condition is "Status Change". When detecting the status is
(A) If select
DIO
changed, it will trigger the event and send the assigned message. (Below is a switch
detecting example.)
On/Off
DIO Trigger: (Detect per 500 ms)
1. Detect initial switch status "Off" (status = 0)
2. Detect "Off" (status = 0, status no change), no trigger
3. Detect "On" (status = 1, status changed), trigger a message notification
4. Detect "On" (status = 1, status no change), no trigger
5. Detect "Off" (status = 0, status changed), trigger a message notification
3. Trigger
UA-5200 Series User Manual V4.3
5. Trigger
204
DIO
and AIO.
Time (ms)
ICP DAS