6.4. MQTT Module
This setting is for UA Controller connecting the remote MQTT module.
This page is for setting the communication values with the connected modules. First
choose the Ethernet LAN port that connected with the module, and each module can give a
name (Default name: Name). Click [
[Edit] button to configure the module content and the MQTT variable table.
Setting Steps:
1. Select the module connecting Ethernet LAN port
2. Give the module name or nickname, e.g. model name DL-302. Default: Name
3. Click the button [
4. Click the button [Edit] to enter the Module Content Setting page
5. Set up the Modbus Mapping Table for the UA controller and module I/O channels
3. Click to add
] button could add a new module, and then click
] to add a new module
152
UA-5200 Series User Manual V4.3
2.
Check the connecting LAN
2. Give a name, Default: Name
4. Click to set the module content
ICP DAS