ICP DAS USA UA-5200 Series User Manual page 119

Note: The "Event Name" and "Key" are set in the IFTTT website. If you are not
with IFTTT, p
lease see the
Advanced Setting > IFTTT Condition Trigger > Content Setting
Input the "Event Name" setting in the IFTTT website.
Event Name
Input the "Key" getting from the IFTTT website.
Key
Status Check to enable the IFTTT condition trigger event.
Advanced Setting > IFTTT Condition Trigger > Condition Setting
Module Select the module and variable for the condition trigger.
Variables Module Type: select the module type, Modbus RTU/TCP/ASCII...
Module Name: select the module that set for condition trigger.
Variable Attribute: select the variable attribute for condition trigger.
Variable Name: select the variable name for condition trigger.
The following condition fields may different depending on the selected variable
attribute. The condition trigger method will be descripted after this table.
Operator Select the operator for the trigger condition.
Value Set up the value for the condition, include Type and Dead Band.
Status Set up the status for the condition. Default: 0.
Add Click to add a condition trigger list in the Condition Table..
UA-5200 Series User Manual V4.3
Appendix C for the setting introductions.
119
ICP DAS
familiar
(Append. C)
(Append. C)