ICP DAS USA UA-5200 Series User Manual page 63

UA-5200 Series User Manual V4.3 ICP DAS
Step 7. Module Setting
This page is for setting the communication values of the connected modules.
The Ethernet port is LAN for connecting with the TCP module, and each module can
give a name (Default name: Name). Click [ ] button could add a new module, and
then click [Edit] button to configure the module content and the Modbus mapping table.
1. Ethernet port: LAN
2.
Give a name,
Default: Name
3.
Click to add
Add a module (No.: 1, Name: Example1) as below, and then click [Edit] button to enter
the "Module Content Setting" page.
4
If set up a wrong module, user can click the box in the left side of the module number
and click the [Remove] button to delete the module.
Click [Edit] can enter the [Module Content Setting] page to set up the module and the
Modbus address mapping table.
63