ICP DAS USA UA-5200 Series User Manual page 64
Iiot communication server
Hide thumbs
Also See for UA-5200 Series:
- Quick start (4 pages) ,
- User manual (79 pages) ,
- Quick start (4 pages)
Table of Contents
Advertisement
Module Content Setting
No.
The module number in the module list (Not editable here)
Module Name
Give a name, e.g. model number or name. Default: Name.
The IP address of the connected module. Default: 0.0.0.0
IP
Port
The port number for Modbus TCP. Default: 502
Set the Slave ID of the UA-5200. (Range: 1 ~ 247)
Slave ID
Timeout
Set the timeout value for the module. Default: 500 ms
Polling Rate
Set a time interval for the command. Default: 500 ms
Modbus Mapping Table Setting
Data Model
System provides 4 Modbus data models
"01" ~ "04" for mapping to address of
DO, DI, AO and AI. (ex. 01: DO
channels, 02: DI, 03: AO, 04: AI)
Start Address
The start address of the Modbus command.
UA controller is start from 0, even if some modules are start from 1,
here it needs to set follow the UA series to start from 0.
Data Number
The number of the Modbus address. Need to give enough number
for the DO, DI, AO, AI channels of the module. Default: 1.
Type
This item only when the data model is 03 or 04. Choose the
suitable data type: 16-bit Short, 16-bit Unsigned Short, 32-bit Long,
32-bit Unsigned Long, 32-bit Float, 64-bit Double.
Create Tables
Click [Add] button, it will add a table in the Modbus mapping table.
UA-5200 Series User Manual V4.3
64
ICP DAS
Note:
the address of
Advertisement
Table of Contents
