Modbus Rtu (Master) - ICP DAS USA UA-5200 Series User Manual

6.1. Modbus RTU (Master)

This setting is for UA Controller connecting the remote Modbus RTU Slave module.
This page is for setting the communication values with the connected modules. First
choose the serial port that connected with the module, and each module can give a name
(Default name: Name). Click [
button to configure the module content and the Modbus mapping table.
Setting Steps:
1. Select the module connecting Serial port
2. Give the module name or nickname, e.g. Example2. Default: Name
3. Click the button [
4. Click the button [Edit] to enter the Module Content Setting page
5. Set up the Modbus Mapping Table for the UA controller and module I/O channels
3. Click to add
] button could add a new module, and then click [Edit]
] to add a new module
137
UA-5200 Series User Manual V4.3
1. Select the connecting serial port
2. Give a name, ex: Example2
4. Click to set the module content
ICP DAS