Acura NSX 1997 Service Manual page 750

Main Menu
Seat Belts
Replacement
SRS wire harnesses are routed near the retractor.
All SRS wire harnesses and connec-
tors are colored yellow. Do not use electrical test
equipment on these circuits.
CAUTION:
• Be careful not to damage the SRS wire
harnesses when servicing the retractor.
• Remove the short connector (RED) from the its
holder and disconnect the SRS wire harness
connector, then connect the short connector
(RED) to the tensioner connector.
NOTE: To prevent dust, wrap the SRS wire
harness connector with a protective cover.
CAUTION: Check the seat belts for damage, and replace them if necessary. Be careful not to damage them during
removal and installation.
1. Remove:
• Seat (see page 20-39)
• Center pillar trim panel (see page 20-38)
2. Remove the three anchor bolts, retractor bolt and retractor mounting bolt, then remove the seat belt and seat belt
buckle.
CAUTION: When removing the retractor, do not touch the seat belt tensioner.
NOTE: When removing the anchor bolts and retractor bolt.
RETRACTOR MOUNTING
BOLT
6 x 1.0 mm
13 N-m (1.3 kgf-m,
9.4 Ibf-ft)
SEAT BELT
TENSIONER
RETRACTOR BOLT
7/16-20 UNF
32 N-m (3.3 kgf-m,
24 Ibf-ft)
SEAT BELT BUCKLE
* CENTER ANCHOR BOLT
7/16-20 UNF
32 N-m (3.3 kgf-m,
24 Ibf-ft)
Disconnect the connector (driver's only).
Table of Contents
RETRACTOR
PROTECTIVE
BAG
RETRACTOR
SEAT BELT
TENSIONER
PROTECTIVE
COVER
SRS WIRE
HARNESS
SRS WIRE HARNESS
CONNECTOR
* UPPER ANCHOR BOLT
7/16-20 UNF
32 N-m (3.3 kgf-m,
24 Ibf-ft)
CENTER PILLAR TRIM
PANEL
(see page 20-38)
SEAT BELT
TENSIONER
CONNECTOR
CONNECTOR
HOLDER
SHORT
CONNECTOR
(RED)
CENTER PILLAR
TRIM PANEL
CAP
* LOWER ANCHOR BOLT
7/16-20 UNF
32 N-m (3.3 kgf-m,
24 Ibf-ft)