Replacement; Windshield Wiper Motor Replacement - Acura NSX 1997 Service Manual

Main Menu
Wiper/Washer
Windshield Wiper Motor

Replacement

1. Open the hood, and remove the cap nuts and the
wiper arms. Don't let the wiper arms hit the hood.
2. Remove the windshield lower molding, hood seal
and cowl cover by prying off the trim clips and
removing the screws (see page 23-295).
3. Disconnect the 5P connector from the wiper motor
assembly, then remove the two mounting bolts and
the wiper linkage assembly.
WIPER LINKAGE ASSEMBLY
4. Remove the three mounting bolts and nut from the
wiper linkage assembly, and remove the wiper
motor.
NUT
18 N-m (1.8 kgf-m, 13 Ibf-ft)
5. Install the wiper motor assembly in the reverse
order of removal.
Table of Contents
5P CONNECTOR
MOUNTING
BOLTS
8 N-m (0.8 kgf-m,
5.8 Ibf-ft)
WIPER LINKAGE
ASSEMBLY
WIPER MOTOR