Acura NSX 1997 Service Manual page 1148

Main Menu
Supplemental Restraint System (SRS)
Cable Reel Installation
CAUTION:
Before installing the steering wheel, the front wheels
should be aligned straight ahead.
Be sure to install the harness wires so that they are
not pinched or interfering with other car parts.
After reassembly, confirm that the wheels are still
turned straight ahead and that steering wheel spoke
angle is correct. If minor spoke angle adjustment is
necessary, do so only by adjusting the tie-rods, not
by removing and repositioning the steering wheel.
1. Align the cancel sleeve grooves with the cable reel
projections.
CANCEL SLEEVE
GROOVES
2. Carefully install the cable reel and the cancel sleeve
on the steering column shaft.
CANCEL SLEEVE
STEERING COLUMN
SHAFT
Table of Contents
CABLE REEL
PROJECTIONS
CABLE REEL
3. Install the column covers.
4. Center the cable reel.
Do this by first rotating the cable reel clockwise un-
til it stops.
Then rotate it counterclockwise (approximately
two turns) until:
The yellow gear tooth lines up with the align-
ment mark on the cover.
The arrow mark on the cable reel label points
straight up.
ALIGNMENT MARK
5. Install the steering wheel, and attach the cable reel
3-P connector to the steering wheel clips.
6. Connect the horn connector and cruise control
connector.
HORN
CONNECTOR
CABLE REEL
3P CONNECTOR
ARROW MARK
CABLE REEL LABEL
YELLOW GEAR TOOTH
CRUISE CONTROL
SET/RESUME
SWITCH CONNECTOR