Acura NSX 1997 Service Manual page 737

Table of Contents

Installation (cont'd)

18. Use suction cups to hold the rear window over the

opening, align it with the alignment marks made in

step 11 and set it down on the adhesive. Lightly

push on the rear window until its edges are fully

seated on the adhesive all the way around.

NOTE: Do not close or open the doors until the

adhesive is dry.

19. After the adhesive is dry, spray water over the rear

window and check for leaks. Mark leaking areas

and let the rear window dry, then seal with sealant.

NOTE: Let the car stand for at least four hours

after rear window installation. If the car has to be

used within the first four hours, it must be driven

20. Connect the rear defogger sub-harness and ground

cable/antenna lead, then install the grommets.

21. Reinstall all remaining removed parts.

Table of Contents

Chapters

Table of Contents