Acura NSX 1997 Service Manual page 819

Table of Contents

Seals/Retainers Alignment

Adjustment (cont'd)

12. Tighten the roof side lock unit mounting nuts and

lock receiver mounting bolts.

13. If you need to adjust the rear end of the roof side seal

to fit against the rear pillar seal, remove the roof,

then adjust the rear end of the roof side seal with a

• Remove the rear end of the roof side seal, then

install the shim.

• Install the roof side seal securely as described on

Table of Contents

14. Check the height of the roof with the body.

If necessary, loosen the lock receiver mounting bolts,

then adjust the height of the roof to make the roof fit

flush with the body by using shims.

Shim locations

Thickness: 1.0 mm (0.039 in)

15. Tighten the lock receiver mounting bolts.

Chapters

Table of Contents