Acura NSX 1997 Service Manual page 992

Main Menu
7. Disconnect the 6P connector.
MOUNTING BOLT/NUT
9.8 N-m (1.0 kgf-m, 7 Ibf-ft) '/•
BRACKET
MOTOR ARM JOINT
8. Remove the two mounting bolts and the mounting
nut.
9. Pry the retractor linkage off the motor arm.
10. Pull out the retractor motor.
11. Install in the reverse order of removal, and:
Make sure there is no interference between the
wire harness and linkage.
Coat the joint with grease, and make sure the
linkage moves smoothly.
Table of Contents
RETRACTOR
MOTOR
6-P CONNECTOR