Acura NSX 1997 Service Manual page 715

Main Menu
19. Carefully lower the glass until you can see its
mounting bolts, then remove them. Pull the glass
out through the window slot.
NOTE:
• Lower the glass by connecting a 12 V battery to
the power window motor (see
• Scribe a line around the mounting bolts to show
the original adjustment.
GLASS
GLASS GUIDE
GLASS
20. Remove the locknuts, then remove the front glass
guide.
NOTE:
• Hold the adjusting bolt with a hex wrench when
removing the locknuts.
• Scribe a line around the locknuts to show the
original adjustment.
FRONT GLASS GUIDE
Table of Contents
section 23).
GLASS
MOUNTING BOLTS
LOCKNUT
ADJUSTING BOLT
LOCKNUTS
21. Remove the mounting bolts and loosen the motor
mounting bolts,
assembly through the window slot.
NOTE:
• Scribe a line around the mounting bolts to show
the original adjustment.
• Take care not to bend the cables.
CABLES
MOTOR MOUNTING
BOLTS
MOUNTING BOLTS
CORROSION RESISTANT BOLT
22. Remove the mounting bolts, then remove the inside
stabilizers from the door.
NOTE: Scribe a line around the mounting bolts to
show the original adjustment.
INSIDE STABILIZERS
*: CORROSION RESISTANT BOLT
then take out the regulator
MOUNTING
BOLT
MOUNTING BOLT
8 x 1.25 mm
22 N-m (2.2 kgf-m, 16 Ibf-ft)
MOUNTING
BOLT