Acura NSX 1997 Service Manual page 604

Main Menu
31. Remove the compliance pivot assembly by remov-
ing the bolts and nuts shown.
COMPLIANCE
PIVOT ASSEMBLY
FLANGE BOLTS
10 x 1.25 mm
58 N-m
(6.0 kgf-m, 43 Ibf-ft)
32. Remove the upper control arm assembly by remov-
ing the flange bolt shown.
Table of Contents
SELF-LOCKING
NUTS
12 x 1.25 mm
Replace.
93 N-m
(9.5 kgf-m, 69 Ibf-ft)
FLANGE BOLT
10 x 1.25 mm
58 N-m
(6.0 kgf-m, 43 Ibf-ft)
Corrosion resistant bolt/nut
NOTE:
• Install the upper control arm on the frame
before installing the compliance pivot assembly.
• Install the compliance pivot bolts and nuts.
Torque them to the specified torque in the order.
1. Loosely tighten the flange bolt
STUD BOLT
FLANGE BOLTS
10 x 1.25 mm
58 N-m
(6.0 kgf-m, 43 Ibf-ft)
FLANGE BOLTS
12 x 1.25 mm
93 N-m
(9.5 kgf-m, 69 Ibf-ft)
2. Insert the stud bolts
3. Install the three flange bolts
specified torque.
4. Install the two flange bolts
specified torque.
5. Tighten the flange bolt
6. Install the 12 mm self-locking nuts
to the specified torque.
SELF-LOCKING
NUTS
12 x 1.25 mm
Replace.
93 N-m
(9.5 kgf-m, 69 Ibf-ft)
UPPER CONTROL
ARM
)
FLANGE BOLT
12 x 1.25 mm
93 N-m
(9.5 kgf-m, 69 Ibf-ft)
Corrosion resistant
bolt/nut
into the frame.
and tighten to the
and tighten to the
and tighten