Acura NSX 1997 Service Manual page 816

Main Menu
17. Scrap or wipe the excess sealant off with a putty knife
or towel.
NOTE: To remove sealant from a painted surface or
the rear pillar seal, wipe with a soft shop towel damp-
ened with alcohol.
18. Let the sealant dry for at least three hours after rear
pillar seal installation.
19. Install the roof on the body, then check that the
seals fit flush (see page 20-107).
If necessary, align the roof side seal by adjusting
the roof side lock unit (see page 20-106).
When you are satisfied that the seal fits properly,
press on the rear pillar portion to make the adhe-
sive stick.
20. Check that each door glass contacts the seals evenly
(see page 20-109).
21. Check for water leaks (see page 20-110).
22. Remove the roof, then reinstall all remaining removed
parts.
Table of Contents