Driver's Window Motor Test; Passenger's Window Motor Test - Acura NSX 1997 Service Manual

Main Menu
Power Windows

Driver's Window Motor Test

Motor Test:
1. Remove the door panel (see
2. Disconnect the 4P connector from the driver's motor.
3. Test the motor by connecting battery power to the
No. 4 terminal and ground to the No. 3 terminal.
Test the motor in each direction, by switching the
leads from the battery.
CAUTION: When the motor stops running, discon-
nect one lead immediately.
4. If the motor does not run, replace it.
Pulser Test:
Connect the test leads of an analog ohmmeter to the
No. 1 and No. 2 terminals and check for needle move-
ment while running the motor by connecting battery
power to the No. 4 and ground to the No. 3 terminal.
The analog ohmmeter needle should move back and
forth alternately.
Table of Contents
section 20).
View from
wire side
PULSER

Passenger's Window Motor Test

1. Remove the door panel (see
2. Disconnect the 2P connector from the motor.
View from wire side
3. Test the motor by connecting battery power to the
No. 1 terminal and ground to the No. 2 terminal.
Test the motor in each direction, by switching the
leads.
CAUTION: When the motor stops running, discon-
nect one lead immediately.
4. If the motor does not run, replace it.
section 20).