Acura NSX 1997 Service Manual page 741

Table of Contents

With a brush, apply a light coat of body primer to

the original adhesive remaining around the rear

hatch frame.

• Make sure the surface is kept free of water, oil

• Do not apply glass primer to the body, and be

careful not to mix up glass and body primer

• Never touch the primed surfaces with your

together on a glass or metal plate.

• Clean the plate with a sponge and alcohol before

• Follow the instructions that came with the

Before filling a cartridge, cut the end of the nozzle

Cut nozzle end

Table of Contents

Apply body primer here.

10 mm (0.39 in)

7 mm (0.3 in)

9. Pack adhesive into the cartridge without air

pockets to ensure continuous delivery. Put the car-

tridge in a calking gun, and run a bead of adhesive

around the edge of the glass as shown.

10. Use suction cups to hold the glass over the open-

ing, align it with the alignment marks made in step

4 and set it down on the adhesive. Lightly push on

the glass until its edges are fully seated on the

adhesive all the way around.

NOTE: Do not open or close the doors until the

adhesive is dry.

ALIGNMENT MARKS

Chapters

Table of Contents