Main Menu
Table of Contents
Countershaft
Disassembly/Inspection/Reassembly
NOTE:
• Lubricate all parts with ATF during reassembly.
• Install thrust needle bearings with unrolled edge of bearing retainer facing washer.
• Inspect thrust needle and needle bearings for galling and rough movement.
•
Locknut has left-hand threads.
• Before installing the O-rings, wrap the shaft splines with tape to prevent damage to the O-rings.
CAUTION: Before installing the 1st-hold clutch O-rings, install the 1st gear collar and thrust washer.