Slave Cylinder Removal; Installation - Acura NSX 1997 Service Manual

Main Menu
Slave Cylinder
Removal
1. Disconnect the clutch hose from the slave cylinder.
Plug the end of the clutch hose with a shop towel to
prevent brake fluid from coming out.
CAUTION: Avoid spilling brake fluid on the painted
surfaces, as it may damage the finish.
2. Remove the slave cylinder from the clutch housing.
Table of Contents

Installation

1. Install the slave cylinder on the clutch housing.
2. Bleed the clutch hydraulic system:
• Attach a hose to the bleed screw, then suspend
the hose in a container of brake fluid.
• Make sure there is an adequate supply of fluid at
the master cylinder, then slowly pump the clutch
pedal until no more bubbles appear at the hose.
• Refill the master cylinder fluid when done.
• Always use Genuine Honda DOT 3 Brake Fluid.
Using a non-Honda brake fluid can cause corro-
sion and decrease the life of the system.