Acura NSX 1997 Service Manual page 702

Main Menu
Electronic Components
Steering Angle Sensor Replacement
Removal
1. Remove the steering column covers.
2. Disconnect the 5P connector from the steering angle
sensor.
3. Remove the steering angle sensor mounting bolts
and washers, then remove the steering angle sensor.
NOTE: Do not lose the adjusting shims used
between the steering angle sensor and sensor
mounting bracket.
CAUTION: Do not damage or drop the steering angle
sensor as it is sensitive.
Table of Contents
Installation
1. Install the steering angle sensor by tightening two
bolts, and make sure the adjusting shims are installed
properly.
CAUTION: Do not apply any grease or oil to the
adjusting shim.
2. Connect the 5P connector to the steering angle sensor.
3. Install the steering column covers.
4. Perform the steering angle sensor system check
(see page 19-125).
NOTE:
• There is no need to select (replace) the shims when
the steering angle sensor is replaced. Use the origi-
nal shims.
• Selection (Replacement) of the adjusting shims
(for adjusting the air gap) is required only when
the steering column assembly (without the sen-
sor) is replaced.