Acura NSX 1997 Service Manual page 713

Main Menu
9. Remove the mounting screws, then remove the
front sash panel from the front sash.
FRONT SASH
10. Remove the outer molding (see page
11. Remove the mounting bolts and locknut, then
remove the front sash.
NOTE:
• Hold the adjusting bolt with a hex wrench when
removing the locknut.
• Scribe a line around the locknut to show the
original adjustment.
FRONT SASH
MOUNTING BOLT LOCKNUT
CORROSION RESISTANT BOLT/NUT
Table of Contents
FRONT SASH PANEL
MOUNTING
SCREW
20-12).
LOCKNUT
ADJUSTING BOLT
MOUNTING BOLT
LOCKNUT
12. Remove the mounting bolt, locknut and adjusting
bolt. Remove the rear sash, then disconnect the
handle rod.
NOTE:
• Before removing the adjusting bolt, measure and
record the clearance
and door.
• Scribe a line around the locknut to show the
original adjustment.
• Take care not to bend the handle rod.
HANDLE ROD
REAR SASH
LOCKNUT
CORROSION RESISTANT BOLT/NUT
13. To replace the outer handle, remove the mounting
screws from the rear sash.
NOTE: Apply grease to the moving surfaces.
OUTER HANDLE
between the rear sash
REAR
SASH
DOOR
LOCKNUT
ADJUSTING
BOLT
MOUNTING BOLT
MOUNTING
SCREW
CAP
REAR SASH