Acura NSX 1997 Service Manual page 1149

Main Menu
7. Install the steering wheel nut.
8. Install the driver's airbag assembly.
TORX BOLT
9.8 N-m (1.0 kgf-m, 7.2 Ibf-ft)
Replace.
Use a Torx T30 bit
9. Connect the cable reel harness to the SRS main
harness below the pedal bracket.
10. Connect the foot light harness and lights-on chime
to the dashboard lower cover, then install the lower
cover.
FOOT LIGHT
Table of Contents
STEERING WHEEL NUT
49 N-m (5.0 kgf-m, 36 Ibf-ft)
Replace.
DRIVER'S AIRBAG
ASSEMBLY
DASHBOARD
LOWER COVER
CHIME
11. Remove the short connector (RED) from the
passenger's airbag and the SRS Service Connector
from the SRS main harness.
12. Reconnect the passenger's airbag 3P connector to
the SRS main harness connector, then reinstall the
glove box.
13. Remove the short connector (RED) from the
driver's airbag and the SRS Service Connector from
the cable reel.
14. Reconnect the driver's airbag 3P connector to the
cable reel 3P connector. Attach the short connector
(RED) to the access panel, then reinstall the panel
on the steering wheel.
15. Remove the short connector (RED) from both seat
belt tensioners, then attach the short connectors
(RED) to their holders.
16. Reconnect the floor wire harness connectors to the
driver's and passenger's seat belt tensioners.